If your vehicle has a timing chain instead of a timing belt, replacement of the timing chain is not required. There are many variables that determine how often an oil change is needed climate, drive time, highway or city street driving, etc. To meet clean air standards, some areas of the United States and Canada use oxygenated fuels to help reduce emissions. Please note that some products whose operation manuals are issued through this service may have been discontinued or the operation manuals themselves may have gone out of print. . Engine oil Check Change Air filter Check Clean Replace Spark plug Check-adjust Replace Spark arrester Clean Idle speed Check-adjust.
Consumers should refer to an for appropriate maintenance information, or see a for service issues. Inspect the filter each time the engine is operated. To order, you will need to know the model name and serial number of your engine. If you cannot find the required operation manual, to purchase it, please contact the shop where the product was purchased, a nearby Honda dealer, or Customer Relations Division of Honda. Refer to the Scheduled Maintenance section of the appropriate owner's manual for specific information. The single most important task for proper gearcase maintenance is inspecting it for signs of leakage after each use.
You will need to clean the filter more frequently if you operate the engine in very dusty areas. Remove any sand, silt or dirt that could potentially damage seals or clog passages. Operation manuals for all Honda products are not provided through this service. Please note that this service is subject to discontinuance or change without notice. To be honest, a complete overhaul is recommended, because corrosion and damage may have occurred if moisture was in the gearcase long enough.
Online Service Information For Dealers and Repair Facilities Only Honda offers a limited selection of online service materials for repair facilities. If you can't find the model name, contact a servicing Honda water pump dealer. Pull the starter grip lightly until resistance is felt, then pull briskly. The bar graph is intended to provide you, our customer, the ability to compare the emissions performance of available engines. If necessary, turn the propeller shaft slowly clockwise when viewed from the shaft end in align the splines. Details of this service Any operation manual issued through this service may not be copied or modified in whole or in part, without the permission of Honda Motor Co. Install the gearcase, while carefully aligning the water tube in the grommet and the driveshaft s~linesto the crankshaft shaft.
For some models, the engine or pump serial number is required. On all motors except the 2. But, in some cases, if the leak was caught in time, and there is no significant wear, damage or corrosion in the gearcase, the propeller shaft seal can usually be replaced with the gearcase still installed to the outboard. If you suspect water in the gearcase, start by draining and closely inspecting the fluid refer to the procedures found in the Maintenance and Tune-Up section. Some engine applications use a remotely-mounted throttle control rather than the engine-mounted throttle lever shown here. If necessary for service or overhaul, drain the gear oil from the gearcase.
How often do I need to change the timing belt on my vehicle? Performing the scheduled maintenance is very important. The model name is usually on the fuel tank or recoil starter of the engine. The gearcase contains the propeller shaft, the driven and pinion gears, the drive shaft from the powerhead and the water pump. Water entering the gear case will usually cause the oil to turn a slightly milky-white color. Taking Care not to damage the driveshaft and the water tube, separate the lower unit from the exhaust housing by pulling straight downward. Engine Shop Manuals and Service Support Materials Like to do-it-yourself? If you have any questions about the precautions described in your product's operation manual, issued through this service, please contact the shop where the product was purchased, a nearby Honda dealer, or Customer Relations Division of Honda.
If necessary for service or access, remove the propeller, for details refer to the procedure in the Maintenance and Tune-Up section. Thoroughly inspect the gearcase and exhaust housing for signs of damage. Then, refill the unit with fresh oil and test the outboard by using it! And, water, mixing with or replacing the oil in the gearcase will wreak havoc with the shafts and gears contained within the housing. Also, significant amounts of water mixed with the oil will give the appearance of an overfilled condition. Not only is it important make sire the oil is at t k proper level not above or below , but it is important to check the oil for signs of contamination from moisture.
Where can I find my radio code? Selecting the Appropriate Owner's Manual To get an owner's manual for your pump, first determine the model name. Precautions and Conditions of Liability Exclusion Concerning Power Products Operation Manuals After accepting the following use conditions, please download the operation manual provided through this service. Watch the fluid level closely after the test, and for the first few outings. These materials are not designed for consumer use. Other conditions Honda is not liable in case of any damage suffered from the use of or inability to use this service.