Orange The projector is in sleep or standby mode. See directly to the projector. Move the projector to position it more directly in front of the screen. Hold the lamp as shown and pull it straight out. Make sure you have a spare lamp handy if the usage hours on this menu are close to the life span of your lamp. Batteries are choking hazards and are very dangerous if swallowed. Wait for the image to appear.
If you want to play sound through the projector, see page 28 for instructions on connecting an audio cable. Follow these steps to replace the lamp: 1. Epson's Extra Care Home Service provides you with the support you need. Turn off the projector and unplug the power cord. One may be included with your video equipment, or you can purchase one from Epson.
To exit the help system, press the If none of the suggestions solve your problem, see additional solutions to problems in the following sections. Avis général : Les autres noms de produit figurant dans le présent document ne sont cités qu'à titre d'identification et peuvent être des marques de commerce de leurs propriétaires respectifs. When projecting from the front, place the projector directly in front of the center of the screen, facing the screen squarely. One may be included with your video equipment, or you can purchase one from Epson. Flashing red Flashing red P Red There is a problem with the fan or temperature sensor.
© 2009 Epson America, Inc. If you are setting up the projector near a wall, leave at least 7. The bright light can damage your eyes. To turn it off, you can press its Ppower button as described below, unplug it, or turn off a power switch that supplies power to the projector. Selecting the image source lets you switch between images input from different pieces of connected equipment. This information is subject to change without notice.
La presente garantie n'est pas transferable. You may need to change the 3. P Red The projector has an internal problem. Stop using the projector, disconnect the power cord, and contact Epson for help, as described on page 81. It may have an icon such as , or it may be labelled. Maintaining the Projector in the Settings menu is.
Flashing red Flashing red P Red There is a problem with the fan or temperature sensor. Lorsque vous avez terminé, appuyez sur le bouton Esc Retour ou Menu pour quitter le système de menus. © 2009 Epson America, Inc. If the picture is taller on one side The projector is set at an angle to the screen. You can connect it to a wide range of video sources and computers, so you can enjoy perfectly adjusted images from all your movies and games. Plug one end of the power cord into the projector, and the other end into an electrical outlet.
See page 50 for more information. This lets you quickly and easily display individual images, or start a slideshow of all the images in a folder. To remove dirt or smears on the lens, use a commercially available cloth for cleaning glasses. Press the foot release lever up and lift the front of the projector. Or you can purchase online at www. Follow these steps to turn on the projector: 1. Epson is not responsible for any use of this information as applied to other products.
Press the button, highlight the menu, and press Menu. The projected image gets darker or starts to deteriorate. Allow a few seconds for the projector to sync up after pressing it. When Power Consumption Info Progressive Resolution you press the button on the remote control, the assigned User menu item is displayed. When the Ppower light stops flashing and remains green, the projector is ready for use. Use this setting to quickly obtain a good picture. PrivateLine is a registered trademark and Extra Care is a service mark of Epson America, Inc.