Each transmitter has a moisture-resistant case and sealed rubber buttons to protect the internal circuitry and 12-volt alkaline battery. Note: If you enter an incorrect digit, turn the vehicle ignition off, then on. Personal Protection Feature Panic The Panic feature sounds the siren and flashes the vehicle parking lights, bringing attention to your vehicle and surrounding area. See your installer for details. Follow the Code Entry Procedure. The status indicator will also flash rapidly. The sensor will be enabled the next time the alarm system is armed.
After 25 seconds, it will blink steadily, once per second. System Maintenance Changing the Remote Transmitter Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. The system will then re-arm, awaiting the next intrusion attempt. Panic is designed to bring attention to the vehicle and surrounding area, warding off a would-be intruder. All entrances protected Opening any door or entrance protected by the security system triggers the alarm's 125db siren and flashes the vehicle parking lights. Adding Remote Transmitters to Your System Your security system has the ability to operate from up to four 4 remote transmitters.
Repeat the procedure in steps 3 and 4, this time using the second number in the code. Impact Detector The impact detector senses any jolts or bumps associated with vehicle intrusion. If the correct code is entered the siren will chirp three times, indicating entry into the Selectable Options Mode. This system is small, convenient and reliable. It may be necessary at times to temporarily disable the lite-touch feature, especially in areas where severe vibration can cause false alarms.
If the correct code is entered, the siren will chirp twice, indicating entry into the Transmitter Programming Mode. The siren will chirp and the parking lights will flash once, and the doors will unlock if equipped and connected. Note: As a security measure, the security system will automatically exit Valet mode if the vehicle ignition is turned on and off more than five 5 times. Your security system has the ability to îðerate from up to four 4 remote transmitters. If the code is lost, it cannot be recovered.
The Interior Status Indicator The Status Indicator is a high-intensity red light mounted in a visible location on the vehicle dashboard. Code Entry Procedure This security system utilizes a secret code for adding or deleting remote transmitters, changing system options and disarming the alarm if the remote transmitter fails to operate. Interior Status Indicator The bright-red warning light is an effective visual deterrent to a would-be thief. The 4 digit code should be written on the front of this manual by your installer If not the code is found on a sticker on the back of the alarm module Below is the procedure for entering the code. Also, each transmitter utilizes Rolling Code technology to deter code-grabbing devices. Press any button on the remote transmitter to turn off the Panic alarm.
The system will respond with three 3 chirps and three light flashes, indicating that the lite-touch feature is disabled. The metal transmitter housing will protect your remote from the wear and tear of being on your keychain while looking sleek and stylish in the process. Although at times you may experience range greater than that, there may be occasions when range is less than normal. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. After two 2 seconds, the status indicator will begin flashing for Code Entry. The courtesy light will turn on for 1 minute, or until the vehicle is started. This is useful when servicing your vehicle.
Test all remote transmitters to ensure that they work properly. It is not necessary to re-program the remote transmitter after changing the battery. The doors will also lock at this time if equipped and connected. Pause at least five seconds in between each press. The system is now fully armed. Follow the Code Entry Procedure.
Your vehicle might already have keyless entry, but very few vehicles come with a remote start system. Trip Identification If the siren chirps four times when disarming, this indicates that the system was triggered in your absence. Do not start the vehicle. The first number has been entered. The receiver inside your vehicle security system and the remote control transmitters are designed together to have an average operating range of 50 feet during ideal conditions. The status indicator will flash twice, indicating the system is in Valet mode.